-
Jaw Crusher Liner Lifter
-
Cone Crusher Liner Lifters
-
Jaw Crusher Liner Lifting Device
Makuri has developed a safer way to lift Jaw Crusher Liner
The Makuri jaw liner lifter is designed to lift the jaws used at Kamoto on the B3 Arbed, B4 Ibag and IPC Sandvik crushers, with a Working Load Limit (WLL) of 3.5 tonnes. Lifting is performed via the cast-in holes on Makuri liners only and is not suitable for use with non-Makuri products.
The lifting pin is inserted into the jaw at 90 degrees to the jaw axis, and once turned locates inside the cast-in slot in the jaw. Lifting is performed via the cast-in holes on Makuri liners only and is not suitable for use with non-Makuri products.
The lifter assembly is designed to lift jaw liners in and out of the crusher, allowing the liners to hang from the assembly at approximately the same angle as the jaw face.
Cone Crusher Liner Lifting Device
Makuri have developed a lifting device for safer and quicker to replace cone crusher liners
Our patented lifting devices for mantle & bowl liner improves safety and installation time
Makuri’s bowl liner lifting device has been used in Australia mines.
MAK-Lift & Fit Chute Liner Lifting Handle
Makuri are developing a lifting device for safer and quicker to replace liner plates
Using MAK-Lift & Fit handle system, chute liner installation can be done easier with less risk of hand injury by holding the liner directly.
Currently we are still in development stage for 2 types of lifting handle.
- Manual lifting handle – 80%
- Automated handle – 60%
Stay tuned for the announcement of our released product.
